Ezdmc Connection Procedure; Finding The Pci-Dmc-A01 - Delta PCI-DMC-A01 User Manual

PCI-DMC-A01/B01 User Guide

3.2 EzDMC Connection Procedure

After you have configured the PCI-DMC-01 interface card and linked modules (such as
driver and motor), if you wish to use EzDMC to test the serial link, you must carry out the
following testing and operating procedure in order.
Step 1: Launch EzDMC.
Step 2: Find the PCI-DMC-01 control card. (see section 3.3)
Step 3: Find linked expansion module devices. (see section 3.4)
Step 4: Motion control on single-axis and multi-axis. (see section 3.6 and 3.7)
Step 5: Stop using expansion device.
Step 6: PCI-DMC-01 interface card reset. (see section 3.8)
Step 7: Exit EzDMC.

3.3 Finding the PCI-DMC-A01

The first menu function (marked with bracket) is the "Search Card" function for finding the
PCI-DMC-01 card. All the PCI cards and their setup in the system can be found using this
function as shown below in Figure 3.2. When Search Card is completed, the device list
shows the status of all found cards as well as the number and setup of master cards.
If the first menu function (Search Card) does not find any PCI-DMC-01 cards, the "No
PCI_DMC_A01 Card Found!" error will pop up as shown in Figure 3.3. Please check that
your PCI-DMC-01 card is properly installed in the system. Or turn off the power and remove
the card. Follow the "2.2.3 Physical Card Installation" process to reinstall the PCI-DMC-01
card on a free PCI slot on the system before trying to find the PCI-DMC-01 card again.
3-2
Figure 3.2
Figure 3.3
Chapter 3 Using EzDMC
July 2014