Table of Contents
Advertisement
Setup and Preparations
Rack-Mounting
Attaching the rack-mount angles
By attaching the included rack-mount angles to this unit, you can
mount it in a rack.
1 .
Remove the screws from the side panels.
2 .
Using the screws that you removed, attach the rack-
mount angles as shown in the illustration.
NOTE
5 Install in a well-ventilated location.
5 Do not block the cooling vents located on the unit's side
panels.
5 Avoid mounting the unit in a sealed-type rack. Warm air
within the rack cannot escape and is sucked into the unit,
making efficient cooling impossible.
5 If the back of the rack cannot be opened, install an exhaust port or
ventilation fan at the top back surface of the rack, where warm air
collects.
5 When using the unit while mounted in a movable case
(portable rack), remove the front and rear rack covers so that the
front and back of the unit are not obstructed.
5 Take care not to pinch your fingers etc. while mounting the unit in
a rack.
Turning the Power On/Off
NOTE
This unit does not have a power switch.
We recommend that you use a commercially available power supply control device to control the AC power of this unit.
When powering up
When powering down
4
Turn on the power in the order of VC-100UHD0source devices0output devices.
Turn off the power in the order of output devices0source devices0VC-100UHD.
Free-Standing Use
Attaching the rubber feet
If you will be placing this unit on a desk or shelf for use, attach the
included rubber feet (4 pcs.). This prevents the unit from slipping or
from scratching the surface on which it is placed.
1 .
Remove the rubber feet from the sheet.
2 .
Peel the double-sided tape off the rubber feet, and
affix the feet so that they cover the four guide holes on
the bottom of the unit.
Advertisement
Table of Contents
