Input Channel Mixing Section-2 - Tascam 12 Owner's Manual

Input channel mixing section-2

4 MODE switches (1-6, 7/8-9/10)
Use these to select the input source for each channel. (see
"Setting the MODE switch" on page 39)
5 COMP knobs and indicators (1-6, 7/8-9/10)
Use these knobs to adjust the compression thresholds for the
signals input to each channel.
When compression is activated, the COMP indicators light.
6 EQ knobs (1-6, 7/8-9/10)
i Use these to boost and attenuate the HIGH, MID and LOW
bands of each channel.
Setting range: ±15 dB
i The central frequencies of the MID bands can be set.
Setting range: 100 Hz - 8 kHz (default: 600Hz)
7 AUX 1 knobs (1-6, 7/8-9/10)
Use these to adjust the levels of signals sent to the AUX 1 bus.
8 POST indicator (shared by all channels)
When this indicator is lit, signals are sent to the AUX 1 bus
after the channel faders. (see "Changing the positions that
signals are sent to the AUX 1 bus from each channel" on page
55)
9 AUX2/FX knobs (1-6, 7/8-9/10)
Use to adjust the levels of the signals sent to the AUX2/FX
bus (POST FADER).
0 PAN knobs (1-6, 7/8-9/10)
Use to adjust the stereo positions of the signals input to each
channel.
NOTE
i When PAN knobs are centered (C), signals are reduced by 3
dB and sent to both left and right MAIN MIX L/R buses.
i When a PAN knob is turned all the way to the left (L), that
channel signal is sent only to the left MAIN MIX L/R bus. It is
not sent to the right bus.
i When a PAN knob is turned all the way to the right (R), that
channel signal is sent only to the right MAIN MIX L/R bus. It is
not sent to the left bus.
2 - Names and Functions of Parts
q REC buttons and indicators (1-6, 7/8-9/10)
Use these to select the channels to record to the SD card.
w MUTE switches and indicators (1-6, 7/8-9/10)
When these switches are on (pushed in, MUTE indicator lit),
those channels are muted.
e Channel faders (1-6, 7/8-9/10)
Use these to adjust the send levels of channel signals.
r MAIN switches (1-6, 7/8-9/10)
Turn these switches on (pushed in) to send channel signals to
the MAIN MIX L/R bus.
t SUB switches (1-6, 7/8-9/10)
Turn these switches on (pushed in) to send channel signals to
the SUB L/R bus.
y SOLO switches (1-6, 7/8-9/10)
Turn these switches on (pushed in) to send channel signals to
the SOLO L/R bus.
When these switches are on, the sound of their channels can
be heard through the SOLO L/R bus with headphones.
When the SOLO MODE screen setting is INPLACE SOLO,
the signals of channels that are not on will be muted. (see
"Setting the solo function for all channels" on page 55)
21
TASCAM Model 12