Hardware Installation
Package Contents
S300-DIN-RDR8S or S300-DIN-I32O16 module
Connectors set
This manual
Tools Needed
Small, straight-blade screwdriver for securing wires in the terminal blocks.
M
OUNTING
The module (RDR8S or I32O16) can be mounted on a flat surface, DIN rail, or in a Johnson
Controls' approved enclosure, such as the S300-DIN-L.
For information on mounting the module in an enclosure, refer to the manual provided with
the enclosure.
DIN Rail Mounting
To mount an RDR8S or I32O16 module on a DIN rail:
1. Fully extend the white clips located on the bottom of the module.
2. Hook the module on top of the rail.
3. Push in the clips.
To remove a module from the DIN rail:
1. Pull down the clips at the bottom of the module.
2. Pull the bottom of the module out and lift it up.
Flat Surface Mounting
To mount an RDR8S or I32O16 module on a flat surface:
1. Make sure no connectors obstruct access to the clips on the bottom of the
module. If necessary, remove the connectors.
2. Fully extend the bottom clips.
3. Mount the module to the surface with mounting screws.
4. Replace the connectors, if previously removed.
4
RDR8S and I32O16 Modules
This document contains confidential and proprietary information of Johnson Controls, Inc.
24-10489-0 Rev. B
© 2010 Johnson Controls, Inc.