Installation; Unpacking The Equipment - Johnson Controls S300 Series Hardware Installation Manual

RDR8S and I32O16 Modules
The key features of the I32O16 include:
Wide range nominal voltage for power source (+12 to 24VDC)

Support for RS-485 bus communications at 9600 or 19200 (Auto baud rate

detection 9600/19200 baud)
32 input/output interface consisting of 8 terminals, each terminal including:

- 4 supervised inputs
- 2 relay outputs
- 2 open collector outputs (OUT1 and OUT2)
The following inputs are shared by all interfaces (one per unit):
- Calibration resistor input
- Supervised panel tamper and power fail inputs
A
PPLICATION
The RDR8S module supports up to eight doors per unit. The I32O16 module supports 32
inputs, 16 relay outputs, and 16 open collector outputs per unit. Both RDR8S and I32O16
use standard RS-485 communications and can interface with the following controllers:
CK722

CK721-A version 3.0 and higher

The RDR8S provides the ability to configure supervised 4-state inputs and unsupervised
2-state inputs. Any points not used for the door can be configured as general purpose
input/output (I/O) points, possibly eliminating the need to purchase additional I/O modules
for certain installations. The RDR8S provides power for the card reader hardware. It does
not provide power for door locking hardware.
The I32O16 provides the ability to configure supervised 4-state inputs, unsupervised 2-state
inputs, and relay outputs. Additionally, 2 open collector outputs per terminal are available.
I
NSTALLATION

Unpacking the Equipment

Carefully inspect the shipping containers as soon as you receive them (with the
delivery agent present). Some shipping companies want to have an agent present
when a damaged container is opened. If a container is damaged, open it
immediately, inspect the contents, and have the agent make note on the shipping
document. Check the purchase order against the packing slips to ensure the order is
complete. If the contents of a container are damaged in any way, notify the carrier
and your Johnson Controls representative immediately. Report any discrepancies to
your Johnson Controls representative. Save the packing materials for possible return
shipments.
24-10489-0 Rev. B
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
Hardware Installation
3