Specifications - Johnson Controls S300 Series Hardware Installation Manual

RDR8S and I32O16 Modules
Output Point Signals
In the following table, n denotes a reader/door number (RDR8S) or a terminal
number (I32O16).
n = 1, 2, 3,4, 5, 6, 7, or 8
Table 3: RDR8S and I32O16 Output Points
RDR8S
"Reader n Red LED"
LEDs
Output is an open collector that
switches to ground.
"Reader n Green LED"
LEDs
Output is an open collector that
switches to ground.
"Reader n Shunt"
SHUNT
Output is a relay.
"Reader n Strike"
STRIKE
Output is a relay.
T S
ECHNICAL PECIFICATIONS
The terminal is expected to operate at moderate temperature variation, non-condensing
humidity variation, moderate vibration, and possible dust contamination.
Item
Input Power
Reader Interface
General Purpose Inputs
Relay Outputs
24-10489-0 Rev. B
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
OUT3
OUT5
Specification
Nominal voltage +12 to +24VDC
48W
2-wire Wiegand* (up to 256 bits)
12VDC, 250mA (typical)
Red indicator
Green indicator
Resistive load
1A max. 0-24 VDC / VAC, 25VA max
Hardware Installation
I32O16
"Terminal n OUT1"
It can be timed, set, reset, fast
flash, or slow flash.
Output is an open collector that
switches to ground.
"Terminal n OUT2"
It can be timed, set, reset, fast
flash, or slow flash.
Output is an open collector that
switches to ground.
"Terminal n OUT3"
It can be timed, set, reset, fast
flash, or slow flash.
Output is a relay.
"Terminal n OUT5"
It can be timed, set, reset, fast
flash, or slow flash.
Output is a relay.
21