Configuring Audio, Hvac And Intercom Zone Control For Each Keypad; Configuring Lighting Zone Control For Each Keypad; Copying A Lighting Scene Layout From Another Dms Keypad In The System - AMX AXT-CA10 Instruction Manual

Using the Design XPress Project Wizard
Once a Keypad Location name has been established, when that Keypad is selected,
the Zone and Lighting Control options (on the right-hand side of the dialog) become
focused on that keypad, as indicated by the text at the top of the section (i.e. Zone
and Lighting Control on DMS keypad 2 (Kitchen)).

Configuring audio, HVAC and intercom zone control for each keypad

1. Select a Keypad Location from the list on the left-hand side of the dialog to set the zones for
that keypad.
2. Select an Audio, HVAC and Intercom Zone from the drop-down list for each DMS keypad, as
desired.
Each Door Phone in the system uses two audio zones.

Configuring lighting zone control for each keypad

Use the fields in the Lighting area of this dialog to set up control for up to 6 lighting scenes per
keypad. For each scene used, AMX Radia lighting system keypad address and button numbers are
required.
1. In the Name field for Scene 1, enter a unique name for this scene (up to 10 characters).
2. In the Address field, enter the address of the lighting system or lighting system keypad
depending upon the lighting system used.
3. In the Button # field, enter the button or scene number that the Design XPress system will
emulate when communicating to the lighting system.
The Design XPress Project Wizard requires that you enter Address and Button #
information for each lighting scene in the system. If for any reason you don not have
access to this information at the time that you are running the Wizard, enter dummy
information so that you can continue through the rest of the Wizard. You can always
re-open this project and return to the DMS Keypads page to enter the information
when it becomes available.

Copying a lighting scene layout from another DMS keypad in the system

Use the Copy From option to copy the lighting scene layout from one DMS keypad in the system
to another:
1. Select the Keypad Location that you want to change the lighting scene layout on.
2. Click the down arrow to display the Copy From drop-down list, and select the keypad that has
the desired lighting scene layout.
3. The scene name, address settings and button numbers are replaced with those from the selected
keypad.
32
from the list (on the right-hand side of the dialog), manually edit the selected name in the
Name field (maximum of 10 characters), and click OK.
For AMX Radia lighting systems, the button # is the number of the scene (stored in the
Radia system) that should be recalled when this scene is selected on the DMS keypad.
Design XPress Programmer's Guide