Step 10 Test And Configure - American Megatrends Enterprise-II User Manual

Step 10 Test and Configure

Review the following points before
powering up:
_ make sure that all adapter cards are
seated properly,
_ make sure all connectors are properly
installed,
_ if the math coprocessor is used, make
sure it is seated properly,
_ make sure there are no screws or other
foreign material on the motherboard,
_ plug the system into a surge-protected
power strip, and
_ make sure blank back panels are
installed on the back of the chassis to
minimize RF emissions.
Start the Test
Plug everything in and turn on the switch.
If there are any signs of a problem, turn
off the unit immediately. Reinstall the
connectors. Call Technical Support if
there are problems.
40
Chapter 2 - Installation