American Megatrends Enterprise-II User Manual page 49

Step 11 Test and Configure,
Continued
BIOS Errors
If the system operates normally, a display
should appear on the monitor. The BIOS
Power On Self Test (POST) should execute.
If POST does not run successfully, it will
beep or display error messages. Beeps
indicate a serious problem with the system
configuration or hardware. The Beep Code
(see page 46) indicates the problem. Make
sure the affected part is properly seated
and connected. An error message is
displayed if the error is less serious.
Recheck the system configuration or the
connections.
Configure the System
Run the AMIBIOS Setup utility. You must
enter the requested information and save
the configuration data in CMOS RAM. The
system will then reset, run POST, and boot
the operating system. See the
documentation on configuring the system
through STANDARD CMOS SETUP which begins
on page 60.
Run the ECU
The Series 16 Enterprise-II is an EISA
motherboard. You must run an EISA
Configuration Utility (ECU) to properly
configure the system. The American
Megatrends ECU and the appropriate
motherboard CFG files are shipped on a
American Megatrends Enterprise-II Motherboard User's Guide
41