Table of Contents
Advertisement
S
ETTING UP FROM A
T
F
S
O ACCESS
IERY
ETUP WIZARD FROM
1 Open an Internet browser and type the IP address of the EX/i Print Server.
2 In WebTools, on the Home tab, next to "Fiery controller initial setup is not complete" click
"Click here to continue."
T
F
S
W
O ACCESS
IERY
ETUP
IZARD FROM
1 In Command WorkStation, as Administrator, do one of the following:
• In the Server menu, click Configure.
• In Device Center, on the General or Users tabs, click Configure.
2 In the Fiery Setup dialog box, click Fiery Setup Wizard.
If you need to access all available options, you may want to click Configure instead. For more
information, see
If you use the Fiery Setup Wizard (from Command WorkStation or WebTools) and click
Finish at the end at the end of the wizard, the Fiery Setup dialog box does not display again in
any location.
C
C
LIENT
OMPUTER
W
T
EB
OOLS
C
W
S
OMMAND
ORK
"About Configure"
on page 31.
TATION
33
Advertisement
Table of Contents
