Xerox EX 570 Configuration And Setup page 28

S P T P 28
ETTING UP FROM THE RINTER OUCH ANEL
Configure options only for the network systems that are currently used at your site. If your
network requirements change, you can change Setup at any time. If the EX/i Print Server is
configured to enable more than one protocol, it automatically switches to the correct protocol
when it receives a print job.
The submenus and options appear in sequence. Default values, where applicable, are
underlined. Words shown in italics indicate a product- or site-specific value.
Server Name
Default server name
Enter a name for the EX/i Print Server (a maximum of 15 characters). This is the name by
which the EX/i Print Server appears on the network.
If you set up more than one EX/i Print Server, do not assign them the same name.
N :
OTE
Ethernet Speed
Auto, 10HD, 100HD, 10FD, 100FD
Choose the appropriate speed of the network. Choose Auto in any of these cases:
• The network speed is unknown.
• The network environment is mixed.
• The network uses 1Gbps.
IPv4 Address Type
Automatic, Manual
Choose whether to allow the EX/i Print Server to obtain its Ethernet IP address automatically
by searching the network.
IP Address
127.0.0.1
If you chose Manual for IPv4 Address Type, enter the EX/i Print Server IP address for
Ethernet. This IP address, unlike an IP address set automatically, remains the same if you
restart the EX/i Print Server. You must change the default to a valid address for your network.
Subnet Mask
255.255.255.0
Set the subnet mask for printing with TCP/IP on your network.
Before proceeding, confirm the subnet mask setting with your network administrator.
Gateway Type
Automatic, Manual
Choose the method for obtaining the gateway address for printing with TCP/IP.