Switching a Source
1
Press SOURCE/POWER.
The source selection screen is displayed.
Screen example
Displays source modes that can be selected
(The kind of source modes that are displayed varies
depending on connection and setting)
2
Press the joystick up or down to select the desired
source, then press
The selected main source screen is displayed.
• In the source selection screen mode, press MUTE/RTN/SETUP to
return to the previous screen.
Adjusting the Volume
Turn the flipper switch clockwise or counterclockwise
to adjust the volume.
Clockwise: Volume up
Counterclockwise: Volume down
Volume: 0 - 35
Lowering Volume Quickly
Activating this function will instantly lower the volume level.
Press MUTE/RTN/SETUP to activate the MUTE mode.
The audio level decreases.
During mute, the volume level indicator will blink.
Pressing MUTE/RTN/SETUP again brings the audio back to its
previous level.
/
/ENTER.
Radio
This unit cannot receive HD Radio™ signals (digital terrestrial radio).
In order to activate the digital radio functions described below, an
optional HD Radio Tuner module must be connected through the
Ai-NET bus.
Band display
Preset number display
Frequency display
Listening to Radio
1
Press SOURCE/POWER.
The source selection screen is displayed.
2
Press the joystick up or down to select RADIO, then
press
/
/ENTER.
3
Press and hold
for at least 2 seconds repeatedly
until the desired radio band is displayed.
FM-1
FM-2
AM
FM-1
4
Press
/
/ENTER to select the tuning mode.
DX SEEK
SEEK
• The initial mode is Distance mode.
DX SEEK (Distance mode):
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
SEEK (Local mode):
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
OFF (Manual mode):
The frequency is manually tuned in steps (Manual tuning).
Joystick
(OFF)
DX SEEK
7
-EN