Setup; General Setup; General Setup Operation; Demonstration Function - Alpine Vehiclehub Pro VPA-B222 Owner's Manual

Setup

GENERAL Setup

General Setup Operation

To display the General mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General mode, as long as the car's ignition has not been turned
off. It is not necessary to repeat the above procedure (1 through
3), of "To display the General mode screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the General mode screen."
The following steps 1 to 5 are common operations to each
"Setting item" of GENERAL Setup. Refer to each section for
details.
1
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
12
-EN
2
Press the joystick up or down to select GENERAL
SETUP, then press the joystick right.
The GENERAL SETUP screen is displayed.
Display Example for GENERAL SETUP Screen
Joystick
3
Press the joystick up or down to select the desired
item.
Setting items:
DEMO / CLOCK TYPE / CLOCK ADJ / DAYLIGHT TIME / BEEP /
REACTOR / SCROLL AUTO
4
Press the joystick left or right to adjust and set the
desired item.
5
Press MUTE/RTN/SETUP to return to the previous
screen. Press MUTE/RTN/SETUP repeatedly to
return to the main source screen displayed before
starting the setup operation.
• Select SETUP on the FUNCTION screen to recall the SETUP screen
after pressing and holding
• Immediately after changing the settings of General Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.

Demonstration Function

This unit is equipped with a demonstration function capable of showing
basic operations of respective sources on the monitor display.
Setting item: DEMO
Setting content: OFF / ON
ON:
OFF: Turns off the demonstration mode.
• The demonstration operation is automatically repeated until the
function is turned off.

Setting the Time Display

The time display type can be set.
Setting item: CLOCK TYPE
Setting content: OFF / 12H / 24H
12H: Clock indication is displayed for 12 hours.
24H: Clock indication is displayed for 24 hours.
OFF: Clock indication is turned off.
/MENU/FUNC. for at least 2 seconds.
Turns on the demonstration mode to show the basic
operations.