Alpine Vehiclehub Pro VPA-B222 Owner's Manual page 53

Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
1
Vehicle Cable
Foot Brake Lead / Parking Brake Lead Connection
FOOT BRAKE
(Yellow/Black)
VPA-B222
PARKING BRAKE
(Yellow/Blue)
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
VPA-B222
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when VPA-B222 is used individually.
• If the switched power (ignition) lead of the VPA-B222 is connected directly to the positive (+) post of the vehicle's battery, the VPA-B222 draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
Speaker Input Lead Connection
1
Cut the car audio's speaker leads.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Pinch Connector
Monitor Cable
Stopper
Pinch
Connector
Pinch
Connector
IGNITION
(Red)
BATTERY
(Yellow)
2
Foot brake lamp
Foot brake lead
Parking brake lamp
Parking brake lead
2
Connect the leads together.
Connect the supplied pinch connector.
Pliers
Foot brake switch
Battery
Parking brake switch
FUSE (5A)
SPST SW (Optional)
(Optional)
FUSE (20A)
(Optional)
Chassis
Battery
51
-EN