Checking the Result of Coating (Sample Coat)
Before coating multiple copies, you can coat a sample of it to check the results of
coating.
IMPORTANT
•
If an optional finisher is attached, [Sample Coat] appears only when you set to coat
multiple copies in the Collate, Offset Collate or Staple mode.
•
If an optional finisher is not attached, [Sample Coat] appears when you set to coat
multiple copies.
1
Set the desired coating modes
IMPORTANT
[Sample Coat] is not displayed if only one copy is set.
2
Press [Start Coating].
NOTE
•
If you select [Specified Pages], specify the page numbers of the output. Note that
the page numbers of the output may be different from those of the stored
document.
•
If you select [Specified Pages], the Staple, Hole Punch, or Booklet mode cannot be
set.
•
You cannot change [All Pages] to [Specified Pages] or vice versa after the sample
coat is output.
•
If you select [Specified Pages], you cannot change the specified pages after the
sample coat is output.
➞
Press [Sample Coat].
Checking the Result of Coating (Sample Coat)
2
2-19