3.3H S/PDIF to ADAT (44.1kHz to 48kHz)
In this configuration, the ADAT optic jacks and the S/PDIF jacks are
used. In the figure below, ADAT #1 is receiving from an S/PDIF
device using a 44.1kHz sampling rate being converted to 48kHz. The
proper control settings for this operation are as follows:
Source = S/PDIF
Destination = ADAT
Destination Rate = 48kHz
Figure 12
3.3I ADAT to S/PDIF (48kHz to 44.1kHz)
In this configuration, the ADAT optic jacks and the S/PDIF jacks are
used. In the figure below, ADAT #2 is transmitting to an S/PDIF
device using a 44.1kHz sampling rate. The proper control settings
36