Table of Contents
Advertisement
In this configuration, the ADAT optic jacks and the AES/EBU XLR
jacks are used. In the figure below, ADAT #1 is receiving from an
AES/EBU device using a 44.1kHz sampling rate being converted to
48kHz. The proper control settings for this operation are as follows:
Source = AES/EBU
Destination = ADAT
Destination Rate = 48kHz
Figure 7
3.3D ADAT to AES/EBU (48kHz to 44.1kHz)
In this configuration, the ADAT optic jacks and the AES/EBU XLR
jacks are used. In the figure below, ADAT #2 is transmitting to an
AES/EBU device using a 44.1 kHz sampling rate. The proper
control settings for this operation are as follows:
Source = ADAT
Destination = AES/EBU
Destination Rate = 44.1kHz
Figure 8
33
Hide quick links:
Advertisement
Table of Contents
