Table of Contents
Advertisement
WhiteBalance Tab
Push lock pin
Set OFF (disable) or ON (enable) for the WB_LOCK on CN2.
Please select "OFF" and save to the camera then reboot the camera if this function does not use it.
Please select "On Push" at the white balance mode.
Note Below "Push Lock" button is disabled when this function is enabled.
White balance mode
ATW mode
The white balance control automatically with the indoor/outdoor judgement and estimate the light source.
ATW mode is less inference for the color saturated target.
All pull in mode
The white balance control automatically without dependence of the indoor/outdoor light source.
The wide rage color pull into the white.
This mode re-adjust the white balance by inference for the color saturated target.
Hold mode
Hold the white balance gain and stop AWB operation.
Saved white balance gain is applied when power on the camera with the hold mode.
MWB mode
The white balance control with the specific color temperature.
User mode
5 sets of the R and B gain are selectable.
OnePush mode
The white balance control automatically by the all pull in then hold the white balance gain and stop the white balance control.
Push Lock button
The white balance control automatically then hold the white balance gain and stop the white balance control.
MWB operation
Set the color temperature for MWB mode.
ATW indoor/outdoor mode
Pull in frame for the indoor and outdoor are selectable.
Pull in the blue sky then suppress red at Outdoor (blue sky) mode.
Other settings
Set the sensitivity for ATW mode and all pull in mode.
STC-S133 Series
Specifications
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
No.16S061-09
35/55
Advertisement
Table of Contents
