Table of Contents
Advertisement
OSD Tab
OSD settings are selectable in this Tab.
For OSD control with the remote control through CN1(Default: Setting)
It is necessary to set "ON" for "Menu Up", "Down", "Left", "Right" and "Enter" then save to the flash memory on the camera.
The OSD function is usable with the remote control that connects to the CN1 after reboot the camera.
For OSD control with the software communication
It is necessary to set "OFF" for "Menu Up", "Down", "Left", "Right" and "Enter" then save to the flash memory on the camera.
The OSD is usable with the control software.
OSD Parameter Load
The camera Default: settings are changed by the OSD when this settings is "ON".
The camera Default: settings are changed by the communication software when this setting is "OFF".
Please set "OFF" and save if the settings that changed by the UART communication as the camera Default: settings.
Save button
Save OSD horizontal and vertical start position for the OSD parameter load is valid.
Note OSD horizontal and vertical start position do not save by "DSP->FLASH" button when the OSD parameter load is valid.
It is necessary to use "Save" button to save the OSD horizontal and vertical start position.
OSD horizontal start position, vertical start position
Set the OSD horizontal and vertical start position (display position).
OSD Time out setting
Set the time out setting for the OSD with second unit.
This function is invalid when set 0.
STC-S133 Series
Specifications
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
No.16S061-09
28/55
Advertisement
Table of Contents
