Filling The Water Tank - TEFAL IS5200 Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

1800121329 IS5200 T-FAL_105x148,5 25/10/10 08:45 Page22

recommended that you carry out a test on part of the

fabric which cannot be seen.

IMPORTANT

Never use water that

contains additives

(starch, perfume,

aromatic substances,

softener, etc) in the

steamer. Additives

such as these can

affect the properties

of the steam and lead

to the formation of

deposits. Never use

water complitely

distilled or

demineralized.

Use

• Only operate the steamer on the floor clear of any

materials which may obstruct the base of the steamer

(flat and horizontal surface). Do not obstruct the

openings on the lower part of the appliance.

• If necessary, expand the pole to the desired height by

unlocking it, pulling it gently and locking it again -

fig.15.

• Plug in the power cord, a beep sound is emitted and

the power light on the front of the appliance turns on

fig.16.

• Hold down the Set/On-Off button located on the

steam head for 2 to 3 seconds to switch on the

steamer.The steamer starts on the minimum steam

output setting. The steam amount can be set to the

desired level by successively pressing the Set/On-Off

button (5 different settings to perfectly adapt the

steam output to all fabric types, from delicate to thick

ones) -

fig.17.

• Ensure that the steamer is unplugged - fig.11.

Remove the water tank from the base of the

appliance by pulling the handle upwards - fig.12.

Unscrew the tank cap and fill the tank. The tank holds

2.35 liters (80 ounces).

• The steamer must to be used with TAP WATER. If the

water in your area is hard, T-fal recommends that you

mix half tap water and half distilled water, which

reduces the hardness. You can also use bottled spring

water or distilled water only.

• After closing the cap, turn the tank down and hold it

by the handle. Check out that no water is leaking

through the cap.

• Place the water tank on the base - fig.14. If you have

any difficulty to placing it, check that the water tank

is not the wrong way round.