Table of Contents
Advertisement
PREPARATION
What water to use?
Your iron has been designed to use untreated tap water.
However, the self-clean function must be performed
regularly on the steam chamber to remove limescale.
If your water is very hard, mix 50% untreated tap water
and 50% distilled water.
• Do not use pure demineralised or pure distilled
water, water from clothes dryers, scented or softened
water, or water containing additives (starch,
perfume, aromatic substances, softeners, etc.), rain
water, filtered, bottled or boiled water, water from
refrigerators, batteries or air conditioners. These types
of water contain organic waste, mineral elements
that become concentrated when heated and cause
spitting, brown staining, leaking or premature wear
on your iron.
*
Filling the water tank
• Always place your iron on a flat, stable, heat resistant
surface
• Unplug the iron before filling it with untreated tap
water only
• Set the steam control to.
• Lift the iron and, holding it at a slight incline, point
the soleplate up.
• Open the water tank cover.
• Fill the water tank to the mark "Max".
Max.
• Close the water tank cover.
Warning ! Do not fill your iron through the scale
collector opening. Do not remove the anti-calc
collector to fill the tank.*
6
*Depending on model
USE
• Plug in the appliance.
Adjusting the temperature and steam
• Set the steam control to
*
• Adjust the temperature control, referring to the table
below.
FABRIC
LINEN / COTTON
*
ECO
WOOL
SILK
SYNTHETIC
(Polyester, Acetate, Acrylic,
Polyamide)
• The temperature indicator light turns on.
• It will turn off automatically once the soleplate
OK
achieves the desired temperature.
Set the temperature control dial to match the type of
fabric you wish to iron. Your iron automatically and
accurately determines the exact steam flow that is
suitable, in order to guarantee the best results.
7
TEMPERATURE CONTROL
POSITION
Max
ECO
••
•
•
= STEAM ZONE
*Depending on model
Advertisement
Table of Contents
