Auto-Off Function - TEFAL IS5200 Instructions Manual

1800121329 IS5200 T-FAL_105x148,5 25/10/10 08:45 Page23
• The steamer produces steam in 60 seconds, when in max position of variable
steam.
• Put the garment directly on the rotating hanger or on another hanger that you
can hang up to the hook. To steam pants, we advise you to use the two hangers
as described in the picture -
• Grasp the steam head with the steam vents pointing away from you. Start
steaming by brushing material lightly with the grain of the fabric in an up/down
vertical motion. The fabric brush opens the weave of the fabrics for better steam
penetration.
• Start at the top the garment and gradually move downward. Always steam in a
vertical position -
• For more ease, we recommend to pull the garment downward with your free
hand while steaming. Be careful not to touch the hot steam.
• During use, the hose may make a gurgling noise. This is a normal occurrence
due to condensation. If you hear the gurgling noise, hold the hose up to direct
the condensation back into the appliance.
Empty tank detector
This appliance is equipped with an empty tank
detector. When the water tank is empty, a beep
sound is emitted for a duration of 1 minute and the
light indicators on the steam head will blink to alert
you to fill the water tank. Turn off the appliance and
fill the water tank.
The appliance will automatically shut off after
1 minute if the water tank remains empty.
Warning : Do not
allow the steamer to
run dry.
Warning : Do not bend
the steam hose during
use or storage.
fig.19.
fig.18.
• This garment steamer is equipped with the Auto-Off
function to ensure optimum safety. Thus, if the steam
head stays motionless for 5 minutes, a beep sound
will be emitted for 2 minutes before the automatic
shut-off.
• The garment steamer automatically turns to « Energy
saving » mode before the automatic shut-off. During
this time, the steam output is significantly reduced in
order to limit the energy consumption before the
appliance completely shuts off.
• Gently move the steam head to reactivate the
appliance.
23
Caution : the empty tank
detector does not work
with fully distilled or
demineralized water. We
recommend you to use
TAP WATER. If the water
in your area is hard, mix
half tap water and half
distilled water.

Auto-Off function