39.6 Cm (15.6 In) Display Assembly - HP ENVY x360 15m Maintenance And Service Manual

39.6 cm (15.6 in) display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Remove the shield (1) that secures the wireless antenna cables to the WLAN module.
2. Carefully disconnect the wireless antenna cables (2) from the WLAN module.
NOTE:
white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna
cable connects to the WLAN module #1 Aux terminal.
3. Release the ZIF connector (3) to which the webcam/microphone module cable is connected, and then
disconnect the webcam/microphone module cable from the system board.
4. Release the wireless antenna cables and the webcam/microphone module cable from the retention clip (4)
built into the top cover/keyboard.
5. Disconnect the display panel cable (5) from the system board.
6. Release the display panel cable from the retention clip (6) built into the top cover/keyboard.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
Computer models have either one or two WLAN antennas. On models with two antennas, the #1
Preparation for disassembly on page
29).
Battery on page
29).
31).