Advertisement
5.
HEADSET COMPONENTS REMOVAL AND REPLACEMENT PROCEDURES
5.1
Moving Cable/Microphone Assembly to Opposite Earcup
a. Removal
1. Using cross-tipped screwdriver loosen three captive screws (3) securing
2. Unplug connector connecting the cable/microphone assembly (2) to the jumper
b. Replacement
1. Plug cable connector from the cable/microphone assembly (2) into the jumper
2. Using cross-tipped screwdriver, secure cable/microphone assembly (2) to the
3. Using cross-tipped screwdriver, secure decorative cover (5) to opposite earcup
Framingham, MA 01701-9168
cable/microphone assembly (2) to earcup assembly (1) and the decorative cover
(5) to opposite earcup assembly (1).
cable coming off the earcup printed circuit board and remove the
cable/microphone assembly.
cable (4) coming off the earcup printed circuit board.
Ensure no wires are pinched during reassembly of the electronics cover
to the earcup assembly.
earcup assembly (1).
assembly.
SIZE
FSCM
A
32108
CAUTION
CLASS
DWG NO.
RF
273139
SHEET
REV.
10 of 25
01D
Advertisement
