Debt Collection; Time Based Debt - 1 & 2; Payment Based Debt - 3; Accumulated Debt - Honeywell AS302P Operating Instructions Manual

28
AS302P Single Phase Smart Meter
____________________________________________________________________
During this period any charge for energy used is accumulated in Debt to Clear.

17.7. Debt Collection

The meter supports Three Different Debts.
The Debt Registers can be configured and adjusted (positively or negatively). Any changes to the debt information are
stored in the Billing Data Log. Any change to debt will only be accepted if the meter is in Prepayment Mode, if in Credit
Mode the command will be rejected with an Alert advising so sent to the WAN.
Debt Information can be viewed on the meter display.
17.7.1. Time Based Debt – 1 & 2
Two separate Time Based Debts can be collected in the meter.
These debts are defined as:
•
The amount of Debt (Outstanding)
•
The Daily Recovery Rate
The Daily Recovery Rate is collected (configured during Manufacture Only):
•
Hourly
•
Daily
Until the debt is fully recovered.
If there is a Power Outage then debt will be recovered for the period of the outage when power is restored e.g. if £1.00 is
to be collected daily and there has been a Power Outage for 3 days then £3.00 will be recovered at power restoration.
If the Daily Recovery Rate is greater than the amount of Debt Outstanding then the Debt Outstanding will reduce to zero
and the difference between DRR and DO will remain on the Meter Balance.
17.7.2. Payment Based Debt – 3
A Payment Based Debt can be collected by the meter when credit is added to the meter. This is calculated as a
percentage of each Credit Top Up.
The Payment Based Debt is defined as:
•
The Total Amount Outstanding
•
Debt Recovery Per Payment (%)
•
Debt Recovery Cap (maximum amount that can be recovered in a week)
The processing of this debt is shown in 34.9.

17.7.3. Accumulated Debt

Accumulated Debt =The debt resulting from the collection of Standing Charge and / or Time-based Debt when Emergency
Credit is in use as configured by Suspend Debt Emergency, when operating in Prepayment Mode. This value will be reset
if a command is received by the meter to reset the Meter Balance.

17.7.4. Aggregated Debt

The Aggregated Debt = Debt 1 Outstanding + Debt 2 Outstanding + Debt 3 Outstanding.

17.7.5. Debt to Clear

Debt to Clear is calculated by the meter as:
i.
ii.
© Honeywell - M450 001 1D - 23.05.2019
Difference between the Meter Balance and the Disablement Threshold plus
Amount of Accumulated Debt plus