Figure 2-6 Em Brake Module Fixing To Inverter; Figure 2-7 Fitting The Control Cable - Siemens MICROMASTER 411 Operating Instructions Manual

УП "Спецпривод-С". http://www.privod.by/. Email: info@privod.by, msv125@mail.ru
Адрес: Республика Беларусь, г.Полоцк, ул. Гагарина 8, комн. 304.
Телефоны: 8 (0214) 444395, 443688, 442155, (029) 6171554
Issue 03/02
Figure 2-6
4. Align the Options case with the Fixing plates (See Figure 2-6).
5. Fasten the Options module base to the fixing plates using the retaining screws
(see Figure 2-6).
6. Feed the supplied control cable between the EM Brake Module and the
corresponding control plug on the inverter I/O board (see Figure 2-7).
Ensure that the Red wire is connected to the Ctrl+ terminal and the Black wire
is connected the Ctrl- terminal (see Figure 1-1 on page 10).
7. Refit the I/O board.
Figure 2-7
8. Using the U-clamp and screw, connect the earth lead (attached to the fixing
plate) to the earth stud (shown as
housing.
9. Feed the EM Brake supply cable and EM Brake Coil connection into the unit.
See Table 2-3
Electromechanical Brake Control Option
6SE6400-5CS00-0BP0
EM Brake Module Fixing to Inverter
Fitting the Control Cable
Power Supply Cable Requirements.
Operating instructions
INSTALLATION
in Figure 2-6) within the module
15