Lens Assembly - Sony BRC-Z700 Service Manual

23. To install, reverse the removal procedure.
m
. Replace the removed tape (L40) with the new tape
(L40).
. When attaching the pulley (P), insert the stick into
the hole of the gear 1 (T) and gear 2 (T) and adjust
the phase.
∅2
2-4
Hole
Gear 1 (T)
Gear 2 (T)
Stick
Stick

2-1-2. Lens Assembly

1. Remove the outer covers (right)/(left).
(Refer to Section 1-2-1.)
2. Remove the inner covers (center)/(right)/(left).
(Refer to Section 1-2-2.)
3. Remove the inner cover (front) assembly.
(Refer to Section 1-2-3.)
4. Remove the inner cover (rear).
(Refer to Section 1-2-4.)
5. Remove the camera cover (upper).
(Refer to Section 1-2-5.)
6. Remove the front cabinet assembly.
(Refer to Section 1-2-6.)
7. Remove the camera cover (lower).
(Refer to Section 1-2-7.)
8. Remove the camera block assembly.
(Refer to Section 2-1-1.)
9. Remove the DD-43 board.
(Refer to Section 2-2-10.)
10. Remove the AD-181 board.
(Refer to Section 2-2-11.)
11. Remove the VC-5 board.
(Refer to Section 2-2-12.)
12. Remove the three screws (BSW2 x 5), then remove
the chassis reinforcing plate.
13. Remove the four screws (BSW2 x 5), then remove the
lens assembly.
n
When removing or attaching the lens assembly, be
careful not to touch the prism assembly in the rear of
the lens assembly.
Camera board chassis
Prism assembly
Lens assembly
14. To install, reverse the removal procedure.
BSW2 x 5
Chassis
reinforcing
plate
BSW
2 x 5
BSW
2 x 5
BRC-Z700