2-2-9. LED-468 Board
1. Remove the outer covers (right)/(left).
(Refer to Section 1-2-1.)
2. Remove the inner covers (center)/(right)/(left).
(Refer to Section 1-2-2.)
3. Remove the inner cover (front) assembly.
(Refer to Section 1-2-3.)
4. Remove the inner cover (rear).
(Refer to Section 1-2-4.)
5. Remove the camera cover (upper).
(Refer to Section 1-2-5.)
6. Remove the front cabinet assembly.
(Refer to Section 1-2-6.)
7. Remove the two screws, then remove the LED-468
board.
LED-468 board
8. To install, reverse the removal procedure.
BRC-Z700
BTP2 x 6
2-15