Writing Of Camera Fpga - Sony BRC-Z700 Service Manual

3-3-5. Writing of Camera FPGA

1. Connect the fixture cable with the connector (CN1201) on the AD-181 board.
S1201
2. Turn on (lower) the switch (S1201) on the AD-181 board.
3. Turn on the power of this unit.
4. Start the camera FPGA writing software iMPACT using PC.
The iMPACT Project window is displayed.
5. When a project is created, select the project and click the [OK] button.
When no project is created, click the [Cancel] button.
n
When no project is created, double-click the "Direct SPI Configuration" in the Flows sub window on
the top left corner of screen.
6. Right-click on main area, then select "Add SPI Device...".
BRC-Z700
CN1201
3-19