A-Video Board-1 - Sony STR-DA2800ES Service Manual

2-21. A-VIDEO BOARD-1

3 Remove wire from lead pin.
3 Remove wire from lead pin.
(See Fig. S)
1 clamp filter (ferrite core)
(FC3)
(See Fig. S)
2 Cut the cable tie.
(See Fig. S)
Note 1: In reassembling, use new cable tie
to fasten the clamp same as before.
Wire setting
< Fig. S >
GUIDE_B board
cable tie
Note 3: The wire must not touch heat sink.
(See Fig. T)
7 connector (CN6506)
6 connector
(CN2516)
4 connector
(CN1406)
3 Remove wire from lead pin.
clamp filter (ferrite core)
(FC3)
MAIN board
3 Remove wire from two lead pins.
(See Fig. T)
5 connector
(CN2100)
3 Remove wire from three lead pins.
(See Fig. T)
I
H
G
qa screw
G
8 connector
(CN6204)
H
9 connector
I
(CN6203)
0 connector
(CN6505)
(See Fig. T)
< Fig. T >
Note 2: The wire must not touch heat sink.
lead pin
Note 3: The wire must not touch IC502, IC507, IC512 and IC517.
STR-DA2800ES
qa three screws
(BVTP3
(BVTP3 8)
– Rear side view –
A-VIDEO board
lead pin
lead pin
CONTROL board
8)
lead pin
29