Front Panel Block - Sony STR-DA2800ES Service Manual

STR-DA2800ES

2-20. FRONT PANEL BLOCK

Note 1: In reassembling, use new cable tie
to fasten the clamp same as before.
8 Remove the front panel block
in the direction of an arrow.
7 two screws
9 Pull out wire.
(BVTP3 8)
0 front panel block
(See Fig. O)
Wire setting
< Fig. O >
DISPLAY board
lead pin
– Ftont panel block inner view –
< Fig. P >
Note 2: The wire must not touch power transformer.
STBY board
28
1 Cut the cable tie.
(See Fig. P)
5 connector
(CN6505)
F
4 connector
(CN6203)
7 seven screws
(BVTP3
USB board
cable tie
6 connector
(CN308)
2 Remove wire from two lead pins.
(See Fig. Q)
F E
E
9 Pull out wire.
D
3 connector
(CN6204)
8)
< Fig. Q >
Note 3: The wire must not touch heat sink.
ACDC board
lead pin
Note 2: The wire must not touch power transformer.
< Fig. R >
Note 3: The wire must not touch heat sink.
lead pin
D
2 Remove wire from two lead pins.
(See Fig. R)
lead pin
MAIN board
lead pin
GUIDE_A board