Table of Contents
Advertisement
6-22. T Reel Motor Assembly Replacement
6-22. T Reel Motor Assembly Replacement
Overviews
Replacement
Manual eject assy removal
Pinch solenoid assy removal
T reel motor assy removal
T reel motor assy replacement
Open the back side of the chassis.
T reel motor assy installation
Driving belt installation
Close the back side of the chassis.
Pinch solenoid assy installation
Manual eject assy installation
Pinch solenoid assy position adjustment
Connector connection
Adjustment after replacement
Servo system adjustment
Tape path adjustment
Preparation
1. Put the unit into the unthreading end state.
2. Turn the power off.
3. Remove the upper panel. (Refer to section 1-5.)
4. Remove the cassette compartment. (Refer to section 1-6.)
n
A clutch plate and retaining ring are pressed in the T reel motor shaft. Prepare a
new clutch (3-169-371-02) and retaining ring (7-624-190-11) when the T reel motor
assy is replaced. (Do not reuse the removed parts.)
Tool
• Torque screwdriver bit (for M2) : J-6325-380-A
• Torque screwdriver (for 3 kg)
• Thickness gauge
6-80
: J-6325-400-A
: 9-911-053-00
DVW-250/250P
Advertisement
Table of Contents
