Table of Contents
Advertisement
6-9. Cue Brush Replacement
6-9. Cue Brush Replacement
Overviews
Cue brush removal
Cue brush installation
Operation check
Preparations
1. Put the unit in the unthreading end mode.
2. Turn off the power.
3. Remove the top panel. (Refer to "1-5. Removal/Installation of Cabinet".)
n
When replacing, prepare a new stop washer (P/N 3-321-393-01).
Tool
• Stop washer fastening tool: J-6323-530-A
Removal
1. Cue brush removal
Remove the stop washer at the top of the cleaner
arm and the cue brush.
Installation
2. Cue brush installation
(1) Insert a new cue brush into the cleaner arm
shaft and put the hole at the bottom of the cue
brush securely in the hook of the cleaner arm.
(2) Attach the cue brush using a new stop washer
while holding the cue lever with fingers.
3. Operation check
Check that the cue brush moves and touches the
CUE/TC head surface for cleaning when the
manual eject gear is turned clockwise and coun-
terclockwise while it is pushed downward.
6-34
CUE/TC head block
CUE lever
Claw
Stop washer
CUE brush
DVW-250/250P
Advertisement
Table of Contents
