Table of Contents
Advertisement
5. Gear block assembly installation
(1) Place a new gear block assembly on the
chassis while inserting the tip of the ST drive
gear shaft of the chassis into the hole of the
gear block assembly.
(2) Attach the gear block assembly using the
three screws.
(3) Put the spring removed in step (2) of 3 on the
hook of the gear block assembly.
(4) Connect the harness connector of the gear
block assembly to connector CN946 on the
MB-601 board.
6. Lid opener assembly installation
(1) Attach the lid opener assembly using the two
screws.
(2) Connect the harness connector of the lid
opener assembly to connector CN944 on the
MB-601 board.
7. Manual eject assembly installation
Attach the manual eject assembly. (Refer to "6-
13. T Reel Brake Solenoid Replacement".)
8. Manual eject assembly position
adjustment
Adjust the position of the manual eject assembly.
(Refer to "6-13. T Reel Brake Solenoid Replace-
ment".)
9. Operation check
Check that the cue cleaner and S and T sliders
smoothly operate when the manual eject gear is
turned clockwise and counterclockwise while it is
pushed downward.
DVW-250/250P
6-18. Threading Motor Replacement
Gear block
Screw
Shaft of ST driving gear
Hook the spring
Screws
6-71
Advertisement
Table of Contents
