6-21. S Reel Motor Assembly Replacement
6-21. S Reel Motor Assembly Replacement
Overviews
Replacement
Connector disconnection
S reel motor assy removal
S reel motor assy replacement
Open the back side of the chassis.
S reel motor assy installation
Driving belt installation
Close the back side of the chassis.
Connector connection
Adjustment after replacement
Servo system adjustment
Preparation
1. Put the unit into the unthreading end state.
2. Turn the power off.
3. Remove the upper panel. (Refer to section 1-5.)
4. Remove the cassette compartment. (Refer to section 1-6.)
Tools
• Torque screwdriver bit (for M2) : J-6325-380-A
• Torque screwdriver (for 3 kg)
• Thickness gauge
Removal
1. Connector disconnection
Disconnect the two connectors (CN951 (S reel
motor) and CN952 (S brake solenoid)) on the
MB-601 board.
6-76
: J-6325-400-A
: 9-911-053-00
CN951
CN952
MB-601 board
DVW-250/250P