Sony HXCU-FB80 Service Manual page 46

2. Remove the DPR-386 board.
(1) Disconnect the flexible flat cable (10 core) from the connector (CN4) on the DPR-386 board.
(2) Disconnect the flexible flat cable (45 core) from the connector (CN402) on the DPR-386 board.
(3) Disconnect the two harnesses from the connectors (CN101 and CN102) on the DPR-386 board.
(4) Disconnect the fine-wire coaxial cable from the connector (CN2) on the DPR-386 board.
(5) Remove the two supplied hex screws, four screws (2.6 x 5) and two screws (BTP3 x 10), then remove the
DPR-386 board.
Harness
Fine-wire coaxial cable
CN101
CN2
3. Install the removed parts by reversing the steps of removal.
HXCU-FB80
Flexible flat cable (45 core)
Harness
CN102
CN402
DPR bracket
DPR-386 board
Flexible flat cable
(10 core)
CN4
2.6 x 5
BTP
3 x 10
Supplied hex screws
3-18