Installation And Commissioning; Hardware Installation - Siemens SIMOCODE pro V Manual

3 Engineering
3.2

Installation and commissioning

3.2.1

Hardware installation

Note Observe all of the setup, assembly and wiring guides of the individual
components as found in their manuals and package slips.
1. Mechanically install the components shown in
2. Establish the power wiring as indicated in
3. Wire the SIRIUS pro V PN basic unit as a reversing starter in accordance with
the quick guide in Getting Started \7\.
4. If, as intended in the application example, you want to display the "ON<",
"OFF" and "ON>" states with indicator lights or illuminated pushbuttons for
local control, use the output "OUT3" (terminal 7) of the basic unit to signal left-
hand rotation "ON<".
Place the 24 V contact supply on terminal 6.
5. If, as intended in the application example, you want to display the "ON<",
"OFF" and "ON>" states with indicator lights or illuminated pushbuttons for
local control, use the output "OUT 1" (terminal 21) of the digital module to
signal the stop state "OFF" and the output "OUT 2" (terminal 22) to signal right-
hand rotation "ON>".
Place the 24 V contact supply on terminal 20.
6. If you do not need status signaling for local control, you can remove the digital
module from the configuration. In the device configuration for "Control
device_1", right-click the digital module and select "Delete" in the context
menu.
Blocking Protection for Pumps with SIMOCODE pro V
Article ID: 109478058, V2.0,
SIRIUS circuit breaker
SIRIUS current/voltage measuring module
SIRIUS contactor combination
09/2020
Figure 2-1.
Figure 2-1.
3-phase input
Motor
22