Table Of Contents - Siemens SIMOCODE pro V Manual

Table of contents

Table of contents
Legal information ......................................................................................................... 2
1 Introduction ........................................................................................................ 4
1.1
1.2
1.3
1.4
2 Operating principle ............................................................................................ 9
2.1
2.2
2.2.1
2.2.2
2.2.3
2.2.4
2.2.5
2.2.6
2.2.7
2.2.8
2.2.9
2.2.10
2.2.11
3 Engineering ...................................................................................................... 20
3.1
3.1.1
3.1.2
3.1.3
3.1.4
3.1.5
3.1.6
3.2
3.2.1
3.2.2
3.2.3
3.2.4
3.3
3.3.1
3.3.2
3.3.3
3.4
3.4.1
3.4.2
4 Useful information ........................................................................................... 62
4.1
5 Appendix .......................................................................................................... 63
5.1
5.2
5.3
Blocking Protection for Pumps with SIMOCODE pro V
Article ID: 109478058, V2.0,
Overview............................................................................................... 4
Delimitation ........................................................................................... 5
Required knowledge ............................................................................. 5
Components used ................................................................................ 6
Logic blocks in use ............................................................................. 10
Explanation of the logic ...................................................................... 12
Embedding ......................................................................................... 12
Detecting faults in the conveying flow ................................................ 13
Switching on via the control station .................................................... 14
Shutting off via the control station or in the event of a fault ............... 15
Manual reversal in the other direction of rotation ............................... 16
Reversal in the opposite direction when conveying fault has
been detected ..................................................................................... 17
Fault shutdown after defined number of reversals ............................. 17
Drive start after fault shutdown .......................................................... 17
Resetting the fault counter during operation ...................................... 18
Blockage in the opposite direction ..................................................... 18
Cyclic communication with the controller ........................................... 18
Hardware configuration ...................................................................... 20
Basic unit (BU) ................................................................................... 21
Detecting irregularities in the conveying flow ..................................... 21
Clearing blockages in the conveying flow .......................................... 21
Digital module (DM) ............................................................................ 21
Operator panel (OP) ........................................................................... 21
Communication with a PLC ................................................................ 21
Installation and commissioning .......................................................... 22
Hardware installation .......................................................................... 22
Installing the software ......................................................................... 23
Downloading configuration and parameterization to the
SIMOCODE pro V PN basic unit ........................................................ 24
Commissioning ................................................................................... 27
Parameterization ................................................................................ 28
Creating the hardware configuration .................................................. 29
Parameter assignment for the SIMOCODE pro V PN ....................... 31
Compile parameterization .................................................................. 53
Operation ............................................................................................ 54
General remarks on Monitoring and Control ...................................... 54
Scenarios ........................................................................................... 59
Time stamping .................................................................................... 62
Service and support ........................................................................... 63
Links and literature ............................................................................. 64
Change documentation ...................................................................... 64
09/2020
3