Table of Contents
Advertisement
EL start angle [deg]
Setup the starting angle of elevation to make a sector blank.
EL end angle [deg]
Setup the ending angle of elevation to make a sector blank.
9) Ground Clutter Rejection
GCR
Turn 1, 2, or OFF Select whether to remove ground
clutter as a target if moving speed is lower than
setting speed.
1: Reject it by using echo data.
2: Reject it by using Reference folder (scr)
OFF: Remain a ground.
Threshold EL angle [deg]
Setup the elevation angle of threshold.
10) Ship Clutter Rejection
SCR
Turn 1, 2, or OFF Select whether to remove ship
clutter as a target if moving speed is lower than
setting speed.
1: Reject it by using echo data.
2: Reject it by using Reference folder (scr)
OFF: Remain a ground.
Threshold EL angle [deg]
Setup the elevation angle of threshold.
11) Doppler Velocity
Doppler Velocity Calculation
Turn ON or OFF to calculate a Doppler velocity.
12) Signal Processing
Rainfall intensity estimation method
Select a type of method of Rainfall intensity estimation.
・ Zh: Use horizontal amplitude information only.
・ Zh,Kr: Zh is calculated from the value that corrected
rain decay by the amplitude.
Output data range resolution [m]
Enter an output data range of resolution
TX power (H) [W]
Enter a value of horizontal power of TX.
Antenna gain (H) [dBi]
Enter a value of horizontal antenna gain
RX gain (H) [dB]
Enter a value of horizontal RX gain.
System Loss (H) [dB]
Enter a value of horizontal system loss.
K square value
Enter a value of K square.
R(Zh)-method coefficient (B)
Enter a value of R(Zh)-method
coefficient "B"
R(Zh)-method coefficient (β)
Enter a value of R(Zh)-method
coefficient "β"
28
S2E-17-0056_A
Advertisement
Table of Contents
