Furuno WR110 Installation Manual page 32

5) Network
SPU type
Select and setup the SPU channel of the ATU.
Manual / Auto (Automatically select type of radar either
WR110 or WR2120)
Command transfer IP
Confirm the IP address of command transfer.
 Constant value: 192.168.31.101
Command transfer port
Confirm the port number of command transfer.
 Constant value: 30100
Data transfer IP
Confirm the IP address of data transfer.
 Constant value: 192.168.31.101
6) TX
PRF pattern
It uses for setting multiple radars.
Select a type of preference pattern 1 to 4 that
registered in the preference folder.
Pulse set
Select pulse number from 1 to 8 to choose the setting.
Each PRF pattern number has different pulse
specification. Values will adjust automatically by using
noise measurement. Furthermore values of A cutback
and ρhv noise level could manually change.
Display range: No.1 = 30km, No.2 = 30km
No.3 = 50km, No.4 = 70km
No.5 = 50km, No.6 = 30km
No.7 = 50km, No.8 = 70km
7) Interference Rejection
IR 1
Turn ON or OFF the IR 1. Basically turn both ON to
reject interference as well. IR 1 will reject the
matched filter (pulse compression).
Note: This is not a level of strength to reject interference.
8) TX Sector Blank
Blank area 1 and 2
Turn ON or OFF a sector blank
AZ start angle [deg]
Setup the starting angle of azimuth to make a sector
blank.
AZ end angle [deg]
Setup the ending angle of azimuth to make a sector
blank.
Data transfer port
Confirm the port number of data
transfer.
 Constant value: 30101
27
S2E-17-0056_A