24
Chapter 1
Getting Started
If you have purchased a new hard disk drive and your computer
cannot detect it or access it after installing it, it may be because your
disk is not physically formatted. Physically format the disk using the
FDISK and FORMAT commands.
Caution: These commands are performed in DOS environment. We
recommend that you familiarize yourself with the DOS commands first
before you format your hard disk.
If you follow the corrective steps above and still receive an error
message, the cause may be an equipment malfunction.
If you are sure that your configuration values are correct and your
battery is in good condition, the problem may lie in a damaged or
defective chip. Contact an authorized service center for assistance.
Note: If you do not know how to contact an authorized service center, call
your distributor.