Table of Contents
Advertisement
Error Message
Equipment Configuration
Error
Expansion ROM Allocation
Fail
Floppy Disk Controller Error
Floppy Drive A Error
Floppy Drive B Error
Floppy Drive(s) Write
Protected
Hard Disk Drive(s) Write
Protected
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
Insert system diskette and
press <Enter> key to reboot
I/O Parity Error
Corrective Action
Run Setup and reconfigure the system.
Contact your dealer or an authorized
service center.
Check the floppy drive cable and its
connections. If the cable is good and
properly connected, the floppy disk
controller may be the problem.
Change the floppy disk controller or
disable the onboard controller by
installing another add-on card with a
controller.
If there is a floppy disk in the drive,
remove it. If there is no floppy disk in
the drive, turn off the system and
check the cable connections. If the
connections are okay and the error
message continues to show, replace
the floppy drive.
Enter BIOS Setup and restore the
setting to "Normal".
Enter BIOS Setup and restore the
setting to "Normal"..
Check the HDD cable connections
and IDE settings in CMOS Setup.
Replace the disk drive or the HDD
(hard disk drive) controller.
Insert a bootable disk in the diskette
drive or remove this disk if a hard disk
drive is installed.
Contact your dealer or an authorized
service center.
21
Advertisement
Table of Contents
