Proxima LightBook 20 User Manual page 20

CONNECTING COMPUTER AUDIO
Use the composite audio cable to connect your audio source to the AUDIO
IN port on the projector.
Figure 1-11 Audio In port
1 Insert one end of the computer audio cable into the Audio Out port of a
Macintosh or the sound card of a PC.
2 Insert the other end into the projector's AUDIO IN port.
NOTE: Although both AUDIO and AUDIO IN may be connected at the same
time, only one can be active. If computer video is selected, AUDIO IN is
active. If NTSC, PAL, SECAM, or S-Video is being viewed, AUDIO is active.
CONNECTING COMPOSITE VIDEO
You can display composite video (NTSC, PAL or SECAM) on the projector.
Figure 1-12 Video In port
Use the supplied composite Video/Audio cable (see page i-2) to connect an
NTSC, PAL, or SECAM source to your projector.
1 Find the RCA connector on your video source marked Video Out or
something similar. This connector is typically yellow. Insert one of the
AV cable's yellow connectors into the Video Out jack of the video source.
2 Insert the other yellow connector into the projector's VIDEO IN port.
In–Audio–Out
R
Video In R
L
Setting Up the Lightbook Projector 1-9