Table of Contents
Advertisement
USER GUIDE
ceiling mount hardware are securely in place and tightened. Use only
well dimensioned ceiling mounts from a renowned supplier. Connect
the projector to a switched mains power supply, and switch off when
not in use, for maximum protection against fire. Switching off using the
remote control only puts the projector in a standby (sleep) mode with
live internal voltages.
10. VENTILATION - Slots and openings in the projector housing are
provided for ventilation. Air inlet filters are employed to reduce dust
build-up internally. Periodically vacuum the filters (from the outside of
the ventilation grilles) as needed. To ensure reliable operation of the
projector and protection from overheating, do not block or cover slots
or openings in any way. Do not insert any foreign objects or
instruments into the slots and openings, as this may block the
ventilation fans. Do not place the projector on a soft surface (carpet
etc.). Never install the projector in an enclosed unit unless it is properly
ventilated by a separate cooling system.
11. HEAT - The projector should be situated away from heat sources such
as sunlight, radiators stoves or other strong heat sources. Do not
operate the projector outside the maximum temperature specifications.
12. OBJECT OR LIQUID ENTRY - Care should be taken so that objects
are not put or do not fall into the projector housing. Be careful not to
spill liquids that may flow into the projector interior. Do not insert metal
or flammable objects into the projector.
13. POWER SOURCES - The projector must only be connected to proper
electrical voltage as marked on the projector body, on the label at the
power inlet. The projector should be connected to the electrical outlet
using a power cord compatible with the local electrical voltage. Never
operate the projector outside the electrical voltage specification. If you
are unsure about the type of electrical service at your location, please
consult your dealer or local power company.
14. POWER CORD PROTECTION - Power cords should be routed so that
they are not likely to be walked on, pinched or unduly bent by items
placed upon or against them. Pay particular attention to cords and
cables at the point where they exit from the projector.
15. GROUNDING OR POLARIZATION - Precautions should be taken so
that grounding or polarization of the projector is maintained. Do not use
a three prong to a two prong adapter.
SXGA LCD PROJECTOR
8
Advertisement
Table of Contents
