Table of Contents
Advertisement
USER GUIDE
3. WORKSTATIONS. If you are using BNC connection to your monitor,
use the BNC cable. Disconnect your GA cable at the monitor end, and
connect it to the short branch of the BNC cable. The long branch
connects to your monitor. A 13W3 adapter is also available if needed.
4. MOUSE
To enable mouse control from the remote control, a connection is
made using a mouse cable and various adapters. Connect the cable
directly to one of the MOUSE connectors on the projector. When no
RS232-control is used, there is one mouse port associated with each
RGB-connector. If RS232-control is used, the mouse must be
connected to MOUSE 1 and RS232 to MOUSE 2. The mouse will then
follow the selected source. Connect the appropriate adapter to the free
end of the mouse cable at the computer end as described below.
SERIAL (RS 232). Use the serial adapter with a branch for the
local computer mouse. The serial adapter is fitted with a 9 pin
DSUB connector. Use an extra 9 to 25 pin adapter (available
from your dealer) if your computer has a 25 pin serial connector.
Connect your computer mouse to the free branch of the adapter
if desired. With some computers, the branched adapter may not
work. For this purpose, an optional straight serial adapter is
available. To control your projector from a remote console,
connect an optional RS232 adapter to the MOUSE 2 input, and
connect it to the console using a standard RS232 cable.
PS/2. Use the PS/2 adapter that connects directly to your
computer mouse port. Running the computer mouse in
parallel is not possible, unless your computer itself has
provision for two mice simultaneously. You may consider
using the above serial adapter and run your mouse on the
serial port instead, in order to be able to run your local mouse
in parallel. This will require a different mouse driver setting.
Please consult your computer documentation or local dealer
for details.
MAC. Use the MAC mouse adapter to connect to the mouse
port on your MAC computer.
5. MAINS POWER
Connect the mains cord to the projector and all other equipment in the
set-up.
SXGA LCD PROJECTOR
13
Advertisement
Table of Contents
