Table of Contents
Advertisement
NOTE:
Should the temperature setting be changed, allow several cycles for the grill plate to adjust.
Once the desired setting has been achieved, note the temperature and keep it set there.
WARNING: Make sure the toaster is in the off position and has been off at least 15 – 30 minutes. Do
not attempt this cleaning procedure if the toaster components are too hot to touch.
Never spray water on the toaster or controls. Damage to the toaster as well as injury could occur.
Severe injury and burns may occur if you do not follow this instruction sheet.
DISASSEMBLY
Turn off main power switch and conveyor switch. Disconnect the power supply cord from the wall outlet. The
toaster will be hot when turned off. Allow the toaster to cool for at least 15 – 30 minutes before handling. USE
CAUTION during disassembly and cleaning. Grasp the left side of the Butter Roller shaft. Lift up and to the
left to remove from drive assembly. Remove the Butter Pan. Remove the Top and Bottom Front Panels.
Daily Parts Cleaning:
The Feeder, and Top and Bottom Front Panel can be placed in a dishwasher or sink and washed with
detergent and warm water.
Daily Conveyor Cleaning:
NOTE: Do not use any chloride or chlorine -based products to clean or rinse toaster or toaster parts.
Conveyor may be hot and is heavy, use caution when lifting and removing. Remove the conveyor
assembly by gripping the two handles at the top and lifting forward until it clears the gears. Lift it up and out
gently placing it in a sink with the drain stopped, or in a suitable container to soak over night. Conveyor can
be placed in the sink or container while warm. Use caution when handling a hot conveyor. The soak
solution is a mix of 10 parts hot water (120ºF or more) to 1 part (minimum) "INSIDE OUT" brand 3-IN-1. Fill
the sink or suitable container with the solution, to completely cover the conveyor by approximately one inch.
Allow the conveyor to soak in the solution over night. Remove the conveyor from the solution. Use a stiff
non- metal brush or plastic pad to remove residual bun oil. Insure the chains are clean and free from debris.
Use a brush to remove any soil or debris remaining on the chain. Rinse conveyor with plain hot water and
allow to drain. Clean and sanitize sink or container after over night use!
Re-Assembly
Before assembling the conveyor check the following: Fasteners on the Conveyor Assembly hardware
should be tight with no signs of wear. Conveyor shaft gear and the Motor Shaft gear are tight. Hanger
Bracket screws are tight and the brackets have not shifted during use.
Lubricate both chains thoroughly with vegetable oil. Bun oil may be used if it contains no animal fats, salts or
dairy products. Note: Chain Lubrication is critical to chain life. Oil the chain daily. Gently replace
conveyor into toaster. Replace all removed toaster parts. Plug power supply cord into wall outlet. Turn main
power switch on. Turn conveyor switch on.
Last Important Note: The conveyor must stay clean to optimize speed and bun temperature. Keep
conveyor looking new.
Daily Griddle Cleaning:
Dry Operation: Wipe off the Teflon sheet with a damp cloth to remove any debris or particles that have
collected on the sheet. If the sheet is worn, replace it with a new sheet.
Wet Operation: It is not necessary to completely remove residue, as long as the grill surface is smooth and
free of burned on bread that may cause buns to stick.
Tools needed for cleaning:
TM
•Scotch-Brite Quick Clean Small Appliance Cleaner No. 702 or Equivalent
TM
•Scotch-Brite Multi-Purpose Pad Holder No. 405 or Equivalent
TM
•Scotch-Brite Squeegee No. 410 or Equivalent
CLEANING
5
Advertisement
Table of Contents
