Table of Contents
Advertisement
temperature setting to achieve desired brownness and temperature.
Should the temperature setting be changed, allow several cycles for the grill plate to adjust.
NOTE:
Once the desired setting has been achieved, note the temperature and keep it set there.
WARNING: Make sure the toaster is in the off position and has been off at least 15 – 30 minutes. Do
not attempt this cleaning procedure if the toaster components are too hot to touch.
Never spray water on the toaster or controls. Damage to the toaster as well as injury could occur.
Severe injury and burns may occur if you do not follow this instruction sheet.
DISASSEMBLY
Turn off main power switch and conveyor switch. Disconnect the power supply cord from the wall outlet. The
toaster will be hot when turned off. Allow the toaster to cool for at least 15 – 30 minutes before handling.
during disassembly and cleaning. Remove the Top and Bottom Front Panels.
CAUTION
NOTE: Do not use any chloride or chlorine -based products to clean or rinse toaster or toaster parts.
Daily Parts Cleaning:
The Feeder, and Top and Bottom Front Panel can be placed in a dishwasher or sink and washed with
detergent and warm water.
Daily Conveyor Cleaning:
Conveyor may be hot and is heavy, use caution when lifting and removing.
assembly by gripping the two handles at the top and lifting forward until it clears the gears. Lift it up and out
gently placing it in a sink with the drain stopped, or in a suitable container to soak over night. Conveyor can
be placed in the sink or container while warm.
solution is a mix of 10 parts hot water (120ºF or more) to 1 part (minimum) “INSIDE OUT” brand 3-IN-1. Fill
the sink or suitable container with the solution, to completely cover the conveyor by approximately one inch.
Allow the conveyor to soak in the solution over night. Remove the conveyor from the solution. Use a stiff
non- metal brush or plastic pad to remove residual bun oil. Insure the chains are clean and free from debris.
Use a brush to remove any soil or debris remaining on the chain. Rinse conveyor with plain hot water and
allow to drain. Lubricate both chains thoroughly with vegetable oil. Bun oil may be used if it contains no
animal fats, salts or dairy products.
Gently replace conveyor into toaster.
after over night use!
Replace all removed toaster parts. Plug power supply cord into wall outlet. Turn main power switch on. Turn
conveyor switch on.
Severely baked on oils as shown in Figure 3 require the conveyor to be cleaned using the one-time boil out
instructions below to clean.
CLEANING
Use caution when handling a hot conveyor.
Note: Chain Lubrication is critical to chain life. Oil the chain daily.
Discard used soak solution. Clean and sanitize sink or container
FIGURE 3
5
USE
Remove the conveyor
The soak
Advertisement
Table of Contents
