Table of Contents
Advertisement
WARNING: Make sure the toaster is in the off position and has been off at least 15 -30 minutes.
not
attempt this cleaning procedure if the toaster components are too hot to touch. Never spray
water on the toaster or controls. Damage to the toaster as well as injury could occur. Severe injury
and burns may occur if you do not follow this instruction sheet.
WARNING: Do not use a grill brick or grill screen to clean the griddle plate. Use of these products
will scrape the plating off of the griddle surface causing buns to stick to the grill plate.
DISASSEMBLY
Turn off main power switch and conveyor switch. Disconnect the power supply cord from the wall
outlet. The toaster will be hot when turned off. Allow the toaster to cool for at least 15-30 minutes
before handling.
Roller Shaft. Lift up and to the left to remove from drive assembly. Remove the Butter Pan. Remove
the Top and Bottom Control Panels.
NOTE:
Do not use any chloride or chlorine-based products to clean or rinse toaster or toaster parts.
Daily Parts Cleaning:
The Butter Roller, Butter Pan, Feeder, and Top and Bottom Control Panels can be placed in a
dishwasher or sink and washed with mild detergent and warm water.
Daily Conveyor Cleaning:
Conveyor may be hot and is heavy, use caution when lifting and removing.
conveyor assembly by simply pushing back on the top row of paddles on conveyor. Conveyor
should loosen from gears and you should grab handles and pull upward. Pull out gently placing it in
a sink with the drain stopped, or in a suitable container to soak over night. Conveyor can be placed in
the sink or container while warm.
is a mix of 10 parts hot water (120ºF or more) to 1 part (minimum) "INSIDE OUT" brand 3-IN-1. Fill
the sink or suitable container with the solution, to completely cover the conveyor by approximately
one inch. Allow the conveyor to soak in the solution overnight. Remove the conveyor from the
solution. Use a stiff non-metal brush or plastic pad to remove residual bun oil. Insure the chains are
clean and free from debris. Use a brush to remove any soil or debris remaining on the chain. Rinse
conveyor with plain hot water and allow to drain.
vegetable oil.
Lubrication is critical to chain life. Oil the chain daily.
Discard used soak solution. Clean and sanitize sink or container after over night use!
Replace all removed toaster parts. Plug power supply cord into wall outlet. Turn main power switch
on. Turn conveyor switch on.
NOTE:
The conveyor must stay clean to optimize speed and bun temperature
Daily Griddle Cleaning:
Wet Operation:
It is not necessary to completely remove residue, as long as the grill surface is smooth and free of
burned on bread that may cause buns to stick. To remove baked-on-bread use the cleaning
procedure below.
Tools needed for cleaning:
TM
Scotch-Brite Quick Clean Small Appliance Cleaner No. 702 or Equivalent
TM
Scotch-Brite Multi-Purpose Pad Holder No. 405 or Equivalent
TM
Scotch-Brite Squeegee No. 410 or Equivalent
TM
Scotch-Brite Griddle Polishing Pad No. 46 or Scotch-Brite™ General Purpose Scrubbing Pad No.
9650 or Equivalent
7. CLEANING
USE CAUTION
during disassembly and cleaning. Grasp the left side of the Butter
Use caution when handling a hot conveyor.
Bun oil may be used if it contains no animal fats, salts or dairy products.
Lubricate both chains thoroughly with
Gently replace conveyor into toaster.
.
Do
Remove
The soak solution
Note: Chain
Advertisement
Table of Contents
