Seagate Scorpion 40 Installation Manual page 35

32
Note: Irix 5.3 and later will detect the changes made and
Irix V6.x through V6.5
To configure Irix 6.x-6.5 to use a Scorpion 40, you must
modify the files /var/sysgen/master.d/scsi and
/dev/MAKEDEV.d/TPS_base, as described below. After
modifying these files you must rebuild the kernel.
1. Edit the file /var/sysgen/master.d/scsi and add one of
For IRIX V6.x through V6.4:
{ DATTAPE, TPDAT, 7, 12, "SEAGATE","DAT
/* This drive uses mode select page 0xf for compression control;
* most of the other drives supporting compression use page 0x10 */
MTCAN_BSF|MTCAN_BSR|MTCAN_APPEND|MTCAN_SETMK|MTCAN_PART|MTCAN_PREV|
MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|MTCAN_SETSZ|
MTCAN_SILI|MTCAN_SEEK|MTCAN_CHTYPEANY|MTCAN_COMPRESS,
/* minimum delay on i/o is 12 minutes, to allow the Drives
* full error recovery sequence to be performed. */
40, 12*60, 12*60, 12*60, 512, 512*512, 0, (u_char *)0 },
For IRIX V6.5:
{ DATTAPE, TPDAT, 7, 12, "SEAGATE","DAT
/* This drive uses mode select page 0xf for compression control;
* most of the other drives supporting compression use page 0x10 */
MTCAN_BSF|MTCAN_BSR|MTCAN_APPEND|MTCAN_SETMK|MTCAN_PART|MTCAN_PREV|
MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|MTCAN_SETSZ|
MTCAN_SILI|MTCAN_SEEK|MTCAN_CHTYPEANY|MTCAN_COMPRESS,
/* minimum delay on i/o is 12 minutes, to allow the Drives
* full error recovery sequence to be performed. */
40, 12*60, 12*60, 12*60, 512, 512*512,
tpsc_default_dens_count, tpsc_default_hwg_dens_names,
tpsc_default_alias_dens_names,
{0},0,0,0,
0, (u_char *)0 },
automatically rebuild the kernel the next time the
system boots.
the following entries, depending on your version of IRIX:
Scorpion 40 Installation Manual, Rev. A
05573"/*DAT*/, 0, 0, {0},
05573"/*DAT*/, 0, 0, {0},