Seagate Scorpion 40 Installation Manual page 19

16
Figure 8
Rear panel of external Scorpion 40
68-pin wide SCSI
connectors
Connecting the SCSI interface cable
The Scorpion 40 provides two 68-pin, shielded connectors on
the rear panel of the enclosure. Either connector can be used
as a SCSI IN or SCSI OUT connection (you can use either
connector to attach the drive to the host computer or to
another SCSI device).
Turn off your computer and all SCSI devices. Then attach a
SCSI cable from the host adapter or from another
(unterminated) SCSI device to the Scorpion 40
Note: The Scorpion 40 will not work in a SCSI-1
SCSI Termination
If the Scorpion 40 is the last device or the only device in a
SCSI chain, you must install a terminating plug on the unused
SCSI connector. See Figure 9 on the following page for two
SCSI termination examples. You can purchase a terminator
for the Scorpion 40 (part number 10006525-001) from
Seagate Express at 1-800-656-8419.
environment.
Scorpion 40 Installation Manual, Rev. A
SCSI ID selector
+
–